Fresh install of OpenSuSE 13.1 + Kolab

[Tom Reijnders]

Ok. I got several steps further:

- I needed to install perl-NatAddr:IP
- I needed to change the httpd.conf file of the ds-admin, line 135. It 
contains the wrong name for the mod_nss module (libmodnss.so was in teh 
conf file, it was called mod_nss.so on disk)

Now I run in to the follwing:


[Setup] Fatal Error: failed to open an LDAP connection to host 
'suse131.tor.nl' port '389' as user 'cn=Directory Manager'. Error: unknown.

Most resources on the internet indicate that suse131.tor.nl is not 
resolvable, but I assure you it is.

Any hints?

Regards,

Tom


Tom Reijnders schreef op 19-4-2014 21:21:
> L.S.,
>
> The instructions for installing Kolab on OpenSuSE 13.1 as described in 
> the installation guide don't seem to work.
>
> 1. The first issue is, that zypper in kolab complains it can't 
> fullfill the requirement mysql-server, if I continue, a lot seems to 
> install just fine.
>
> 2. Then, running setup-kolab fails with the following errors:
>
> Setup is now going to set up the 389 Directory Server. This may take a 
> little
> while (during which period there is no output and no progress 
> indication).
>
> An error was detected in the setup procedure for 389 Directory Server. 
> This setup
> will write out stderr and stdout to /var/log/kolab/setup.error.log and
> /var/log/kolab/setup.out.log respectively, before it exits.
>
> The file /var/log/kolab/setup.error.log conatins the following:
>
> Can't locate NetAddr/IP/Util.pm in @INC (you may need to install the 
> NetAddr::IP::Util module) (@INC contains: /usr/lib64/dirsrv/perl 
> /usr/lib/perl5/site_perl/5.18.1/x86_64-linux-thread-multi 
> /usr/lib/perl5/site_perl/5.18.1 
> /usr/lib/perl5/vendor_perl/5.18.1/x86_64-linux-thread-multi 
> /usr/lib/perl5/vendor_perl/5.18.1 
> /usr/lib/perl5/5.18.1/x86_64-linux-thread-multi /usr/lib/perl5/5.18.1 
> /usr/lib/perl5/site_perl .) at /usr/lib64/dirsrv/perl/DSUtil.pm line 75.
> BEGIN failed--compilation aborted at /usr/lib64/dirsrv/perl/DSUtil.pm 
> line 75.
> Compilation failed in require at /usr/lib64/dirsrv/perl/Setup.pm line 67.
> BEGIN failed--compilation aborted at /usr/lib64/dirsrv/perl/Setup.pm 
> line 67.
> Compilation failed in require at /usr/sbin/setup-ds-admin.pl line 24.
> BEGIN failed--compilation aborted at /usr/sbin/setup-ds-admin.pl line 24.
>
> What is the best way to proceed? All the documents I find elsewhere 
> are describing ways that don't work with the given repositories.
>
> Thank you!
>
> Tom
>

-- 
--

Tom Reijnders
TOR Informatica
Chopinlaan 27
5242HM Rosmalen
Tel: 073 5226191
Fax: 073 5226196