Fresh install of OpenSuSE 13.1 + Kolab

[Tom Reijnders]

L.S.,

The instructions for installing Kolab on OpenSuSE 13.1 as described in 
the installation guide don't seem to work.

1. The first issue is, that zypper in kolab complains it can't fullfill 
the requirement mysql-server, if I continue, a lot seems to install just 
fine.

2. Then, running setup-kolab fails with the following errors:

Setup is now going to set up the 389 Directory Server. This may take a 
little
while (during which period there is no output and no progress indication).

An error was detected in the setup procedure for 389 Directory Server. 
This setup
will write out stderr and stdout to /var/log/kolab/setup.error.log and
/var/log/kolab/setup.out.log respectively, before it exits.

The file /var/log/kolab/setup.error.log conatins the following:

Can't locate NetAddr/IP/Util.pm in @INC (you may need to install the 
NetAddr::IP::Util module) (@INC contains: /usr/lib64/dirsrv/perl 
/usr/lib/perl5/site_perl/5.18.1/x86_64-linux-thread-multi 
/usr/lib/perl5/site_perl/5.18.1 
/usr/lib/perl5/vendor_perl/5.18.1/x86_64-linux-thread-multi 
/usr/lib/perl5/vendor_perl/5.18.1 
/usr/lib/perl5/5.18.1/x86_64-linux-thread-multi /usr/lib/perl5/5.18.1 
/usr/lib/perl5/site_perl .) at /usr/lib64/dirsrv/perl/DSUtil.pm line 75.
BEGIN failed--compilation aborted at /usr/lib64/dirsrv/perl/DSUtil.pm 
line 75.
Compilation failed in require at /usr/lib64/dirsrv/perl/Setup.pm line 67.
BEGIN failed--compilation aborted at /usr/lib64/dirsrv/perl/Setup.pm 
line 67.
Compilation failed in require at /usr/sbin/setup-ds-admin.pl line 24.
BEGIN failed--compilation aborted at /usr/sbin/setup-ds-admin.pl line 24.

What is the best way to proceed? All the documents I find elsewhere are 
describing ways that don't work with the given repositories.

Thank you!

Tom

-- 
--

Tom Reijnders
TOR Informatica
Chopinlaan 27
5242HM Rosmalen
Tel: 073 5226191
Fax: 073 5226196