fetchmail does not inject into kolab

[Dieter Kluenter]

Richard Bos <radoeka at xs4all.nl> writes:

> Op maandag 4 juli 2005 21:16, schreef Dieter Kluenter:
>> I run fetchmail as root with following /etc/fetchmailrc
>>
>> ,----[ fetchmailrc ]
>>
>> | poll mail.isp1.org
>> | proto pop3
>> | ssl
>> | user <LOGIN>
>> | pass <PASSWORD>
>> | is user1 at mydomain.com
>> | #
>> | poll mail.isp2.org
>> | proto pop3
>> | user <2nd LOGIN>
>> | pass <2nd PASSWORD>
>> | is user2 at mydomain.com
>> | # keep
>>
>> `----
>>
>> This fetchmailrc runs perfectly since kolab-0.9 (with changes to the
>> user attribute of course, and occasinally uncommenting keep)
>
> That's what I would expect here as well.  That is why I'm so surprised it just 
> does not work...  Does it have to do 'luck' ;)
>
> I'm using fetchmail from my distribution (suse93) and not from kolab.  Is that 
> an issue?  Are there any changes needed at the service tab, I'm thinking of 
> the following ones:
> - Privileged Networks
> - SMTP "smarthost/relayhost"
> - Accept Internet Mail
> - Mail Filter Settings
>   Check messages for mismatching From header and envelope from. 
>   Use the Sender header instead of From for the above checks if Sender is 
> present. 

I have installed Kolab2 on a SuSE-9.2 system and I'm using the system
fetchmail as well, without any problems. As far as I remember from
your original posting, you had some additional parameters on the
command line, so I would check the validity of this parameters.

-Dieter 
-- 
Dieter Klünter | Systemberatung
http://www.dkluenter.de
GPG Key ID:8EF7B6C6