Setting up SSL on Kolab 3 [Scanned]

[William Reynolds]

I do not have any apache folder in /etc

So where the heck would it be? Kolab 3 was installed on a fresh install of CentOS 6.4 minimal installation. I also have not set it up yet for Cyrus on port 993 or 995

Wm. Reynolds
President | Co-Founder
www.rrwds.com

A Dell Registered Partner
Small & Medium Business
State & Local Government


 Please consider the environment before printing this email.

-----Original Message-----
From: Henning Hollermann [mailto:henning at hollermann.de] 
Sent: Saturday, May 11, 2013 10:30 AM
To: William Reynolds
Subject: Re: Setting up SSL on Kolab 3 [Scanned]

Its /etc/apache2/conf.d/ or /etc/apache2/sites-available/. Did you setup it as well for cyrus on Port 993?

Am 10.05.2013 23:18, schrieb William Reynolds:
> I have my new SSL cert and private key without passphrase enabled.
> Im going to combine them into PEM format for postfix. Where do I make 
> the changes for apache? I looked in the /etc folder and didnt see an 
> apache folder.
> 
> Thanks Will