Kolab-users Digest, Vol 99, Issue 16

[Jeroen van Meeuwen (Kolab Systems)]

On 2012-05-10 17:17, Nazeer wrote:
> Ok, I reverted back to snapshot after I installed CENTOS and followed 
> the
> kolab guide (just before running kolab setup step)
>
> I then ran setup and got the same error...
>
> I then did killall -9 httpd and then service httpd start and it 
> started fine
>
> However, I still cant access the Server from a broswer
>
> I tried IP Address (it's a static IP) and I tried the FQDN which 
> points to
> that server and it just says connection failed
>
> What am I doing wrong?
>
> I even tried service kolabd stop and then start afterwards and still 
> nothing
>
> I also rebooted and still cant access the Ip or FQDN
>
> Any suggestions?
>

Check the firewall on the server and adjust as necessary.

I think a default installation includes a command-line interface 
'setup' that gets you to modify the firewall. Alternatively look at 
/etc/sysconfig/iptables.

Kind regards,

Jeroen van Meeuwen

-- 
Systems Architect, Kolab Systems AG

e: vanmeeuwen at kolabsys.com
m: +44 74 2516 3817
w: http://www.kolabsys.com

pgp: 9342 BF08